Use your Particle Electron or Photon* or Bluz Bluetooth LE (Low Energy) to monitor energy with this 2-Channel 120V AC high-accuracy Voltage monitoring controller.
This controller handles all Voltage calculations for energy monitoring applications. Use our Particle library to communicate energy monitoring data to the Particle cloud or adapt our library for your specific application using the Arduino wire language.
This device provides an ideal energy monitoring solution for most industrial and commercial applications at a low cost with unmatched accuracy.
This controller includes 2 off-board Voltage sensors (transformers) and an I2C cable for measuring 120VAC mains voltage.
This controller uses I2C communications to talk to your Particle Photon or Particle Electron, freeing your Particle GPIO pins for other applications.
This controller includes 120VAC Voltage sensors (US Version AC Wall Plug) with 1.5 Meter wires (around 5 feet).
This controller includes an I2C expansion port and I2C cable so you can easily expand into other current monitoring controllers, sensors, relay controllers, FET drivers, and much more.
For AC Current Measurement Only. This controller is tuned specifically for the included sensors, and may not be used with any other sensor. Included sensors (transformers) do not provide power to this device. This controller requires a separate 12VDC power supply. The sensor rating of this controller is 120V AC(USA). Never exceed 110% of the rated Voltage range of this controller (120V AC) or permanent damage to the controller may result. To achieve highest possible accuracy, each channel may require further calibration. This controller dedicates 1.3 seconds for measurement of each channel and cycles through all available channels continuously. We recommend querying this controller every 10 seconds for best results.
*Particle Photon/Electron/Bluz not included.
Requires 12V Power Supply, the Included Transformers are for measurement ONLY and will not power this controller.
IoT Motherboard Compatibility
This is an I²C Master Device, capable of directly connecting to any of our Cross-Platform I²C Slave Devices using the I²C Output. It is directly compatible with:
If using a Particle module, the PKFR Key Fob Receiver overlay shield may be used.
This device may be converted for direct use with:
Arduino Nano using the Arduino Nano Adapter
Arduino Micro using the Arduino Micro Adapter
Onion Omega 1&2 using the OC Adapter
Pycom WiPy using the WiPy Adapter
Adafruit Huzzah ESP8266 using the Adafruit Huzzah Adapter
This device may be converted to an I²C slave device using the Slave Adapter, ideal for use with Raspberry Pi, Beaglebone, Arduino Uno, and BridgeX5.
Use the Slave Adapter and a Arduino Uno Interface Adapter
Use the Slave Adapter and a Arduino Nano I²C Shield
Use the Slave Adapter and plug into any Arduino Nano Master Device
Use the Slave Adapter and plug into any Arduino Micro Master Device
Raspberry Pi Interfaces:
Use the Slave Adapter and a Raspberry Pi I²C Interface Adapter
Use the Slave Adapter and a Raspberry Pi 2/3 I²C Interface Adapter
Use the Slave Adapter and a Raspberry Pi Zero I²C Interface Adapter