4-Channel On-Board AC Current Monitor for I2C
- Solid Core Current Sensors
- High Accuracy
- 0x2A I2C Start Address
- Expandable to 16 Devices per I2C Port
Current monitoring of your AC power loads is now possible using cross-platform I2C communications, making current monitoring possible for your Raspberry Pi, BeagleBone, Arduino, or any other computing platform that supports I2C.
Monitor current and keep track of your power consumption using your favorite computing platform. This controller has four monitoring channels, precision tuned to monitor the current flow through the on-board current sensor with a 3% or 5% maximum error rate (See Technobabble below).
To use this device, simply run an AC power wire, up to 10 AWG in size, through the center of the sensors. The on-board custom designed CPU will do the rest using I2C communications.
This controller includes an I2C expansion port, allowing expansion for more current monitoring inputs or other types of I2C sensors and devices. Four on-board address jumpers allow expansion of up to 16 current monitoring devices through the I2C expansion port. Mix and match current monitoring controllers of any size to meet your specific application requirements.
Software developers can take advantage of our ControlEverythingCom GitHub repository for current monitoring and programming samples.
This device only requires a 12VDC power supply for operation, which may be plugged into the controller using a 2.1mm center positive barrel connector or on-board terminal block for direct wired power supplies.
This is a general purpose I²C device compatible with all computing platforms and IoT technologies, including Raspberry Pi, BeagleBone, Arduino, Particle, BridgeX5, and many more. All ControlEverything.com devices support a strict +5V I²C Bus standard.
Arduino Nano and Micro Interfaces:
Plug this Device into the Arduino Nano I²C Shield
Plug this Device into any Arduino Nano Master Device
Plug this Device into any Arduino Micro Master Device
Plug this Device into the Arduino Uno Interface Adapter
Onion Omega 1 & 2 IoT Interface:
Use our Onion Omega Adapters
Particle IoT Interfaces:
Plug this Device into the Particle Photon I²C Shield
Use as Expansion for any Particle Photon Device
Use as Expansion for any Particle Electron Device
Note: All devices above are compatible with Bluz Bluetooth Interface
Windows 8/10 PC Interface:
Use the Bridge Series Controller
We use 2 different sensors for our on-board current monitoring products. The available accuracy and amperage configurations are:
- 5 Amp
- 10 Amp
- 15 Amp
- 20 Amp
- 10 Amp
- 20 Amp
- 30 Amp
- 50 Amp
- 70 Amp
These devices are tuned for reading current up to the selected amperage. Exceeding the selected amperage through the core sensor may damage the on-board CPU. For best accuracy, we highly recommend choosing a controller with the lowest possible amperage rating required for your application.
This device is designed for AC current measurement only and cannot be used to monitor DC loads. This device is typically more accurate than commercially available clamp meters and nearly as accurate as most direct wired meters. This device will arrive pre-set to a calibration value that was known to work well in our master designs.
For higher accuracy, users may adjust our recommended calibration settings. All current monitoring controllers require half of a second to analyze and compute a current monitoring result for all channels. For best performance, we suggest communications with this device no more than once per second.