This Analog to Digital Converter Board is capable of reading 0-20V input voltages. It has an onboard Amplifier for signal conditioning. This Board uses two MCP3428 to read the amplified Signal. The MCP3428 is a 4-Channel Analog to Digital Converter with 16-Bit resolution, ideally suited for low-speed high-resolution sensor monitoring. The MCP3428 is capable of reading analog voltages at 15 samples per second with 16-Bit resolution or 240 samples per second at 12-bit resolution. The MCP3428 has an x1, x2, x4, x8 programmable gain amplifier, making it an ideal choice for monitoring extremely low-voltage sensors. All 8 channels are capable of monitoring a full-scale range of 0-20V. Up to 8 MCP3428 devices are capable of sharing a single I2C communication port using floating address inputs.
This 0 to 20V Analog to digital Converter board has two MCP3428 onboard. To use both MCP3428 at the same time you will need to set them to different addresses. This Analog to Digital Converter board has onboard jumpers to select the different addresses for both of the MCP3428.
Note: Set MCP3428 gain at one to read 0-20V Signal and set the gain at two to read 0-5V Signal.
This is a general purpose I²C device compatible with all computing platforms and IoT technologies, including Raspberry Pi, BeagleBone, Arduino, Particle, BridgeX5, and many more. All ControlEverything.com devices support a strict +5V I²C Bus standard.
Arduino Nano and Micro Interfaces:
Plug this Device into the Arduino Nano I²C Shield
Plug this Device into any Arduino Nano Master Device
Plug this Device into any Arduino Micro Master Device
Plug this Device into the Arduino Uno Interface Adapter
Onion Omega 1 & 2 IoT Interface:
Use our Onion Omega Adapters
Particle IoT Interfaces:
Plug this Device into the Particle Photon I²C Shield
Use as Expansion for any Particle Photon Device
Use as Expansion for any Particle Electron Device
Note: All devices above are compatible with Bluz Bluetooth Interface
Windows 8/10 PC Interface:
Use the Bridge Series Controller