This DC Current Monitoring controller consists of ADS7828 12-bit analog-to-digital converter connected to eight ACS712-05 hall-effect current sensors.
This controller uses I2C communications with a convenient I2C input and I2C output connectors for easy daisy-chaining. On-Board address jumpers allow device start address selection for up to four current monitoring controllers on a single I2C port.
To use this device, simply pass current through each pair of screw terminals and read the voltages on the ADS7828. The ADS7828 will return approximately 2.5V when 0 current is passed through the ACS712. Forward current will cause the ADS7828 to return values between 2.5 and 5VDC as current increases. Negative current will cause the ADS7828 to return values from 2.5 to 0 as current increases. In theory, this design could monitor AC, but our software currently supports DC only at this time.
This is a general purpose I²C device compatible with all computing platforms and IoT technologies, including Raspberry Pi, BeagleBone, Arduino, Particle, BridgeX5, and many more. All ControlEverything.com devices support a strict +5V I²C Bus standard.
Arduino Nano and Micro Interfaces:
Plug this Device into the Arduino Nano I²C Shield
Plug this Device into any Arduino Nano Master Device
Plug this Device into any Arduino Micro Master Device
Plug this Device into the Arduino Uno Interface Adapter
Onion Omega 1 & 2 IoT Interface:
Use our Onion Omega Adapters
Particle IoT Interfaces:
Plug this Device into the Particle Photon I²C Shield
Use as Expansion for any Particle Photon Device
Use as Expansion for any Particle Electron Device
Note: All devices above are compatible with Bluz Bluetooth Interface
Windows 8/10 PC Interface:
Use the Bridge Series Controller