The WPKF is a Key Fob Receiver/Decoder shield compatible with Linx Technologies MS Series Key Fob Transmitters operating at 418/433MHz (1, 2, 3, 4, 5, 8-Button Transmitters Available Separately). This device is capable of receiving button presses from a remote control up to 750 feet away (when using the 8-Button remote). When a remote control button is pressed, the on-board Valid LED illuminates. In addition, WiPy I/O lines are asserted High for the duration of the remote button press. WiPy I/O lines return to a low state when the remote control button is released.
Includes RP-SMA Antenna.
The On-Board LICAL Key Fob Decoder is Mapped to the following WiPy Pins:
Key Fob Button 0 is Connected to WiPy GPIO0
Key Fob Button 1 is Connected to WiPy GPIO3
Key Fob Button 2 is Connected to WiPy GPIO4
Key Fob Button 3 is Connected to WiPy GPIO5
Key Fob Button 4 is Connected to WiPy GPIO14
Key Fob Button 5 is Connected to WiPy GPIO15
Key Fob Button 6 is Connected to WiPy GPIO16
Key Fob Button 7 is Connected to WiPy GPIO17
NOTE: Key Fob remotes are security encrypted, and must be paired with the controller prior to use. This is an Overlay Shield and does NOT directly plug into the WiPy. This Overlay Shield REQUIRES a ControlEverything.com controller with Double-Row Headers on each side of the WiPy module interface. To use an overlay shield, WiPy devices are plugged into a ControlEverything.com controller, which has two rows of pins on each side of the WiPy module. This shield installs over the top of the WiPy, using the outer set of pins of the ControlEverything.com controller to make contact with the WiPy module. Please examine photos carefully to see how overlay shields are installed.
Key Fob remote control transmitters can be found here.
For more information on the WiPy, check out: https://www.pycom.io/
This is a general purpose I²C device compatible with all computing platforms and IoT technologies, including Raspberry Pi, BeagleBone, Arduino, Particle, BridgeX5, and many more. All ControlEverything.com devices support a strict +5V I²C Bus standard.
Arduino Nano and Micro Interfaces:
Plug this Device into the Arduino Nano I²C Shield
Plug this Device into any Arduino Nano Master Device
Plug this Device into any Arduino Micro Master Device
Plug this Device into the Arduino Uno Interface Adapter
Onion Omega 1 & 2 IoT Interface:
Use our Onion Omega Adapters
Particle IoT Interfaces:
Plug this Device into the Particle Photon I²C Shield
Use as Expansion for any Particle Photon Device
Use as Expansion for any Particle Electron Device
Note: All devices above are compatible with Bluz Bluetooth Interface
Windows 8/10 PC Interface:
Use the Bridge Series Controller